Sherpa Cable Clip

Sherpa Equipment Company recommends against taking racks through a carwash. (Found on general FAQ page)

Installation typically involves twisting the clips into the extrusion crossbars. Most rack installs take a few hours, but these clips are a simple twist-in accessory. (Inferred from general FAQ and product description)

Sherpa products generally employ rubber seals and washers, so silicone is not required for most installs. (Found on Sherpa Edge page)

Sherpa Cable Clips are designed for 10-series aluminum extrusion crossbars. They will fit any rack — Sherpa or otherwise — that uses matching 10-series T-slot extrusion.

It depends on your setup. For a single light-bar wire run, 4-6 clips is typical. For a full multi-circuit setup with lights, USB, and antenna cables, 10-25 clips gives you clean, spaced routing. They're sold in packs of 10, 25, and 50.

No tools required. The clips twist into the extrusion channel by hand and lock in place.

Sherpa accessories are covered by a Lifetime Warranty to the original retail purchaser against defects in workmanship or materials.

Yes. Every Sherpa product is designed, machined, and finished in the USA — most within 500 miles of Sherpa's Berthoud, Colorado shop.

This accessory uses standard 1/4"-20 hardware with drop-in T-nuts to bolt into Sherpa's 10-series aluminum extrusion crossbars. It will also work on any rack or panel that accepts 1/4" bolts.